Flanged Covers are turned down approximately 3/4” on each side. Flanges provide a limited degree of weather and dust proofing and also may be gasketed for more complete dust or non critical weather proof operation. They are secured by means of bolts, screw clamps or toggle clamps.
Flat Covers fit flush with housing top flanges. They may be bolted, spring clamped or attached with screw clamps or toggle clamps. Altough flat covers are intended primarily for interior applications, they also may be gasketed for moderate dust proof operation
Flared Trough Covers are standard flared covers for flared troughs. They may be bolted or fastened with screw clamps or toggle clamps.
Hip Roof Covers are designed for outside applications. The center peak of the cover sheds rain or snow. Both sides of the cover are flanged to provide additional weather proofing. These covers also may be gasketed for more severe weather proofing operation. Covers may be bolted or attached by means of screw clamps or toggle clamps.
Shroud Cover is designed for use with standard U-trough when a tubular cross section is required. Standard covers frequently are used with the shroud cover to prevent accumulation of foreign matter or moisture in the pockets formed by the contour of the shroud and the sides of the housing.
Domed Cover is intended primarily for applications where fumes or heat must be vented from the housing. Ventilation lines are readily attached to this type of cover. The domed cover is built to specifications to suit individual requirements. Specific applications should referred the Newton Conveyors’ Engineering Department.
